Usage

Single-sided type

Double-sided type

Usage Methods

The rubber part of the main body is extended by tightening the clamping bolt using an allen key and clamps the workpiece on the metal part. When unclamped, it returns to its original dimensions due to the compression of the rubber.

Single-sided type

Double-sided type

Set the position where the workpiece is clamped by referring to the mounting dimensions taking into account variations in workpiece dimensions.
The locating for clamping direction can be set using the included locating pin.
You can also clamp the workpiece vertically.(LWC-04 cannot)

Single-sided type

Double-sided type

Component Parts

Single-sided type

Double-sided type

Component Parts 1 Main body (metal part) 2 Main body (rubber part) 3 Clamping bolt 4 Main body (metal part) 5 Knock pin φ3

Mounting Dimensions

Single-sided type

No. a (Coarse Thread) b c d LWC04 M4 × 0.7 - 4.7 - 4.9 - LWC06 M6 × 1.0 φ 3H7 depth 4.5 ± 0.2 7.9 - 8.2 6 LWC08 M8 × 1.25 φ 3H7 depth 4.5 ± 0.2 10.1 - 10.7 8 LWC12 M12 × 1.75 φ 3H7 depth 4.5 ± 0.2 12.4 - 13.2 10

Double-sided type

No. a (Coarse Thread) b c d Maximum Difference Between Left and Right LWCD04 M4 × 0.7 - 4.7 - 4.9 - 0.2 LWCD06 M6 × 1.0 φ 3H7 depth 4.5 ± 0.2 7.9 - 8.2 6 0.3 LWCD08 M8 × 1.25 φ 3H7 depth 4.5 ± 0.2 10.1 - 10.7 8 0.6 LWCD12 M12 × 1.75 φ 3H7 depth 4.5 ± 0.2 12.4 - 13.2 10 0.8

Cautions

In this product, NBR (synthetic rubber) and adhesive are used in the main body
Do not use solvents such as paint thinner, chlorine-based cutting fluids, or strongly alkaline cutting fluids as these can cause the rubber in the main body to damage.
Do not open wider than the specified opening. Doing so may cause the rubber to break.